VACUUM OWEN

• Temperature range Tambient + 5°C ÷ 200°C
• Simple microprocessor controller with an LCD display
• Optional settings of 10 different automatic programmes and optional manual control
• A selection of an optional temperature  'steps' in each programme from 1 to 10
• Operation delay of the vacuum pump (possible to set the pre-heating first and then the vacuumization or reverse)
• Start-up operation delay (start-up at a specified time and day)
• Subject temperature display
• Vacuum analogue display
• Display and temperature setting resolution 0.1°C
• Temperature stability ±0.1°C
• Programme for a simple temperature calibration
• RS 232 communication port (printer or PC)
• Needle valve for inlet of the inert gas (venting or inlet of the gas when the procedure is completed)
• Additional reserve plug NW-40 (for calibrations)
• Observation glass with an additional protective glass
• Safety thermostat
• Two-stage silicon seal
• The interior casing is made of stainless steel AISI 304 (optional AISI 316) 
• The exterior is made of aluminized sheet, powder coated (RAL 7035)  (optional AISI 304) 
• Shelf temperature display  (SC label at the end of the type)
• Heated shelves (SC label at the end of the type )
• Vacuum control and vacuum digital display (SC label at the end of the type)

All required documentation (IQ & OQ optional)

In addition we also manufacture industrial vacuum dryers with different volumes and configurations even for the EX environment.